debugging

Single step debugging is supported. You can debug a single component break point and output the debugging error content to the console debugging tab.

The commissioning steps are as follows:

First stepSelect the second and fourth lines to set variable component break point debugging, and click the blank position in front of the component serial number to mark the component with breakpoint identification.

Step 2Then click the debugging button on the top of the factory to conduct one-step debugging.

Step 3When running to the second line of components, the components will be marked by the red box and stop running. If there is an error, the error content will be displayed under the debugging tab of the console. If there is no error, you can click the serial number ② Continue debugging.